This post has been de-listed
It is no longer included in search results and normal feeds (front page, hot posts, subreddit posts, etc). It remains visible only via the author's post history.
9
Z-offset
Post Body
Hello,
is it normal that you have to set a new z offset value after every print ? My printer doesnt save the value, although I do a SAVE_CONFIG . Should I use an other command?
Kind regards
Comments
[not loaded or deleted]
Author
Account Strength
60%
Account Age
3 years
Verified Email
Yes
Verified Flair
No
Total Karma
6
Link Karma
5
Comment Karma
1
Profile updated: 3 days ago
Subreddit
Post Details
We try to extract some basic information from the post title. This is not
always successful or accurate, please use your best judgement and compare
these values to the post title and body for confirmation.
- Posted
- 3 years ago
- Reddit URL
- View post on reddit.com
- External URL
- reddit.com/r/voroncorexy...
I spent 2 whole hours trying to figure this out. Did a Z offset calibration, changed the end stop to the number on the screen, and proceeded to put a nice scratch on my bed. Reverted my changes and proceeded to print in mid air. Finally realized that the Endstop pin is the relation of the pin to the bed and not the bed to the pin.
Technically the manual suggests grinding the pin to be level with the build plate. However, if I grind away too much, Iām stuck changing the off set anyway. So I just adjusted it in klipper.