So I am new to 3d Printing and trying to figure out what my problem is here. I printed a few things without much issue, but the last two things that I have printed have been nothing *but* issues. the prints stick heavily to the bed, so much so that they end up leaving bits and pieces behind. I have tried taking the prints off of the bed when it is still warm and I have tried when it has fully cooled - no difference. The only difference between the prints that "worked" and those that "didn't" is that i changed from the black Snapmaker filament to the white Snapmaker filament. Could this be the issue?

​

I am printing with the Luban "Normal Quality" profile as-is.

Do I need to use a higher (or lower) bed temperature? Do I need to change layer height - or initial layer height? Is my z-offset wrong? How can I go about finding this out?

​

Here is a picture of what I am getting. (note: yes I scratched my finger trying to get this off the bed).

​

​

https://preview.redd.it/grzyb6euznf61.jpg?width=3024&format=pjpg&auto=webp&s=a6b7443cbb6d5603633f3ae1de5e9b237d8d946e