When I bought this bike (2006 Buddy 125 ~5000 odo) last summer, the shop I bought it from changed all the fluids etc before I picked it up, so I haven't changed the oil on it yet because I just rolled over 6k this week. Today I finally had some free time to get it done, but when I went to remove the drain plug, it was on there SO TIGHT from the shop that it almost immediately just sheared all over. It's stripped pretty good, and it's still on there pretty tight. Maybe I'm lucky but I've never had this issue before, anybody know of any effective methods I could try to get it removed and replaced? I've never tried to drill out a bolt that was holding back fluid like that before. Any help is greatly appreciated!!