There are 2 ways to setup a wifi connection using RagerX:

1. (easier, faster, less options) Using RagerX GUI flasher
2. (for advanced users) Using commands in terminal

In this short tutorial I will show you how to flash RagerX image on your USB drive for usage with Wi-fi.

1. Using RagerX GUI flasher

​

1. Insert your USB drive and start \"RagerX Flasher Utility.exe\" and choose your USB drive in the dropdown

​

2. Choose RagerX OS image version. (just in case - these images are stored in \"roms\" folder of the flasher utillity)

​

3. Enable \"setup Wifi\" option and enter your network name and password.

​

4. Enter your pool username and pawword. If you have several workers (and USB drives) - you can name them to distinct in stats.

​

5. Optionally you can enable USB verification after flashing is finished. Press \"flash\" button

​

6. Press \"ok\" and reboot your PC. Boot from USB (set usb drive as the first boot device in BIOS) and enjoy!

​

2. Using commands in terminal

In order to configure wi-fi in command mode, you need to initialise device, enter network name and its password and assign IP address to it:

1. Do you want to change keyboard layout? No
2. Available interfaces are: wlan0. Which one do you want to initialise: wlan0
3. Available wireless networks: yournetworkname. Type the network name to connect to: yournetworkname
4. Type the yournetworkname pre shared key (password): yourpassword
5. Ip address for wlan0? dhcp
6. Successfully initialised WPA supplicant. RagerX will reboot to finish installation and continue mining