This is the stock CURA Start GCODE and the only change I did was to lengthen the line to make sure the nozzle is primed. Any other changes I can make to optimize this?

M201 X500.00 Y500.00 Z100.00 E5000.00 ;Setup machine max acceleration

M203 X500.00 Y500.00 Z10.00 E50.00 ;Setup machine max feedrate

M204 P500.00 R1000.00 T500.00 ;Setup Print/Retract/Travel acceleration

M205 X8.00 Y8.00 Z0.40 E5.00 ;Setup Jerk

M220 S100 ;Reset Feedrate

M221 S100 ;Reset Flowrate

G28 ;Home

M420 S1 Z2 ;Enable ABL using saved Mesh and Fade Height

G92 E0 ;Reset Extruder

G1 Z2.0 F3000 ;Move Z Axis up

G1 X10.1 Y10 Z0.28 F5000.0 ;Move to start position

G1 X10.1 Y250.0 Z0.28 F1500.0 E15 ;Draw the first line

G1 X10.4 Y250.0 Z0.28 F5000.0 ;Move to side a little

G1 X10.4 Y10 Z0.28 F1500.0 E30 ;Draw the second line

G92 E0 ;Reset Extruder

G1 Z2.0 F3000 ;Move Z Axis up