Hello all,

Can't quite find a solution to this on video tutorials or this sub.

I installed the CR touch on my Ender 3 v2 last night.

I eventually installed the correct firmware for my motherboard (4.2.2).

I had it do a level, then I adjusted the z offset until it just grabbed a sheet of paper.

I went into Creality Print and added the bit of code to initiate the 9 point bed check before each print.

Downloaded a new bed test .stl and sliced it with the new bit of code and tried printing it.

It auto homed, did the 9 point test, then started 'printed'. The nozzle stayed well above the bed, and just extruded PLA pasta.

Am I missing something still?