Hello, I'm having difficulties to determine my optimal measurements. The biggest difficulty is because of my situation down there.

I'm working with A LOT of foreskin, a grower, thin flaccid girth (head thinner/just as thin as the rest of the) dick. Depending on if i retract/pull my foreskin or not it adds 5-6mm of girth and 6-10mm of length

My exact measurements are:

Flaccid (normal) length : 67-70mm

Flaccid shaft girth (normal): 28mm

Flaccid head girth(normal): 25-27mm

Flaccid (retracted) length: 60mm

Flaccid shaft girth(retracted): 30-33mm

Flaccid head girth(retracted) 25-26mm

Erect length: ~140mm/ 14cm

Erect shaft girth: 33-35mm

Erect head girth: 34mm

So as you can see my dick is a bit special in that the head most of the time isn't much bigger than my shaft.

Now one would think that I only need to let it stay normal and not retracted or the other way around but I've read so many different opinions from people on Reddit and chastitymansion that there is no general conclusion how one should wear it.

If I were it normally I have a thinner flaccid dick with foreskin poking out and the pinching pain is a no no for me. Also urine gets trapped in foreskin so it's unhygienic. If I retract it it gets puffy. A bit like a frilly lizard but then I get edema if my foreskin isn't being squished like a noodle in the noodle press.

So I think I need a thin cage to suppress the edema that isn't too long nor too short. I wish I could just buy some cheap and thin diameter cages from Amazon or a knockoff but thin cages are (almost) nowhere to find aside from kink3d which is way too expensive (EU) to just "try them out IF they even fit" or going custom.