Brand new Chiron. Was working flawlessly for the first ten days. No issues after I made sure everything was tightened.

Last night I start a print only to wake up this morning and see it just stopped mid print. No error message, nothing on the screen, it just stopped

Re sliced the file thinking maybe that's why. True to print again, less than two minutes in it does the same thing.

I swapped sd cards, tried again. Same thing..

Powered it off, looked to see if there were any loose connection on the board, everything was fine and seated properly.

Plug it back in and power on. Screen doesn't turn on. Z stops blink red lights and magic smoke starts coming from the board

I got this printer 11 days ago. I'm not happy with anycubic right now.

I started a ticket with them but at this point i just want my money back so I can get something else.