Hey all. I've posted about making fully water soluble and fast acting cannabinoids before, but I think I have my recipe dialed in pretty dang perfect now.

I wanted to have 100 mg/ml (1 dropperful), with taste that would disappear, and hopefully be fast acting.

I started using polyorbate 80 recently and I posted a video showing the technique--here is that video-

https://youtu.be/Hu25PxMnYkM?si=YcgyZznXsIGxRjXk -the technique is solid but here is the new recipe I recommend

First of all know I have to make at least 4 fluid ounces because my mixer has to have at least that much liquid to work effectively. If your mixer is smaller you could make less.

So I'm going for 100mg cannabinoids per each ml of liquid (one dropperful) so I have to start out with some math

So-4 ounces is 120 ml and I want each ml to have 100 mg of cannabinoids, so I need 1200 mg (12 grams of pure distillate-more if it is less pure)

I want an equal amount of oil as my distillate--I have switched to MCT oil (from coconut oil) for this purpose I believe the thinner liquid at room temp nature of it is helpful.

We then have to figure out how much polysorbate 80--appx .5% of your total recipe is what I had read, but I based my calculations on using 1:1 water--so about 50 grams total, so I was going for about 1/4 of a gram (but ended up with more like 1/3--is ok).

So since my distillate & oil are 24 grams, got 3 1/4 cups ounces of hot (not quite boiling) water ready and in my mixer. Pour my warmed and blended distillate/oil mix & the polysorbate in the mixer and let it blend on high for about 15 minutes.

The result is a thin milky looking liquid that after sitting has a very slight "oil slick" look on top, but doesn't seem to want to separate even after sitting overnight.

I tried it out in a N/A beer and it dissolved right away and I couldn't taste it. I also tried it in a small glass of milk (where it should be more obvious) and I couldn't taste it there either, so it should disappear in most everything.

1200 mg worth of distillate, RSO, or activated concentrate 12 grams of MCT oil 1/4-1/3 gram poly sorbate 80 3 1/4 cupsounces hot water

This recipe makes each 1ml dropperful appx 100 mg and each drop appx 5 mg. For many people making it half as strong would make a lot of sense--just cut the distillate, oil, and PS80 in half and increase the water by about 12 grams and you'll be good to go.

edit: fixed ounces not cups