This post has been de-listed
It is no longer included in search results and normal feeds (front page, hot posts, subreddit posts, etc). It remains visible only via the author's post history.
So I'm kinda new to FPV. After watching Josh Bardwell's videos on Betaflight, I decided to flash firmware to 4.4.3... When I did it was successful and I went to configure my 'hawk and noticed the Accelerometer and gyro calibration buttons greyed out. So I went ahead and flashed back to factory firmware and restored my backup CLi dump. Still same problem. Went through binding process and it seemed to bind to my Radio, so I went through setting up modes and switches. But when I tried to arm it... Nothing. Connected my goggles and got video feed, only my OSD was flashing between "NoGyro" and "BadRx". I really need some help with this. If there is anything I can do other than buy a whole new AIO and install it. And BTW, I was just out flying it not 30min before this and it was flying fine. Or seemed to be, because I didn't notice anything out of the norm. But I'm sending out an S.O.S. Any advice is tremendously appreciated!
And P. s... Any of y'all old heads see what I did up there?? ☝️ 🎶Sending out an SOS🎶... Sorry.. had to break my aggravation just a little before I really broke something.
Yes. I configured it all from my CLI dump, which I made 30 min after it's first flight.
Receiver is SPI and BetaFlight isn't registering any gimbal movement. Only reason I know it bound was the LED on the board
Subreddit
Post Details
- Posted
- 8 months ago
- Reddit URL
- View post on reddit.com
- External URL
- reddit.com/r/TinyWhoop/c...
Thanks. I'll watch it here in a few min and see if I can figure this out.