Hello! I need to stay within Thrustmaster ecosystem in order to play on PS3, but I want Load Cell, HEART sensor, and GT mounted pedals. Looking at SimRacingGarage's video of the T-LCMs, when he opens it up, it looks like the gas connector and clutch connector can be very easily interchanged. Is it possible to swap those connectors causing the Gas/Clutch to switch, in order to mount them inverted? The gas and Clutch connector seem the same size, where as the brake pedal is smaller than the other two. I suppose this is because the brake uses a load cell, whilst the gas and clutch are both HEART sensors. Here is the video in question, as well as timestamps where the board and connectors I am talking about are visible:https://www.youtube.com/watch?v=StPXcYVPKwo&t=2380s

30:3031:20 (best shot, as you can see the clutch and gas going to the edge connectors, and the load cell brake going to the centre connector. It seems that both the clutch and gas are 7 pin, whilst the load cell brake is 6 pin. They also all appear to have a clip disconnecting system, meant to be plugged in and out. )36:30 its possible to get a clear shot of the connectors.37:24 VERY clear but offset shot. You can even see where it says clutch, brake, and gas on the board. I presume the connectors simply relay the HEART sensor's reading to the board, and then the board takes that reading and processes it for the gas/clutch into the game. So if the connectors get swapped and the pedals are mounted inverted, the clutch(now gas) will send this information the to Gas section of the board, and the gas(now clutch) will send this information to the clutch part of the board. The brake obviously being irrelevant, as it's in the centre.