This post has been de-listed
It is no longer included in search results and normal feeds (front page, hot posts, subreddit posts, etc). It remains visible only via the author's post history.
Hello All.
In advance, I literally know nothing on the backend workings, so just know on that side I am very much a beginner. I have the SV06 Plus and 6 months ago I added the SOVOL Klipper screen. It had been booting and printing just fine until a few weeks ago. Then the Klipper screen would only cycle and not boot up. I found that printer.cfg was empty so I copied it from the backup version and pasted it into the main one. Booted up fine. If I turned the machine off, each time I would restart it same issue. I would copy the backup and past it in the main. After a few times the back-up was empty and still will not boot. Luckily I saved it in notes and copied and tried to past it in the main config. Would not save. no matter what I deleted it would not save. Now I have removed the Klipper screen and back to the original screen on the SV06. Plus. I have tried to reflash the firmware to no success. I am not sure what more information to give to help me figure out what I need to do, I am at a complete loss.
Subreddit
Post Details
- Posted
- 3 months ago
- Reddit URL
- View post on reddit.com
- External URL
- reddit.com/r/Sovol/comme...