So I'm kinda new to FPV. After watching Josh Bardwell's videos on Betaflight, I decided to flash firmware for the F411RX AIO to BetaFlight4.4.3... When I did it was successful and I went to configure my 'hawk and noticed the Accelerometer and gyro calibration buttons greyed out. So I went ahead and flashed back to factory firmware and restored my backup CLi dump. Still same problem. Went through binding process and it seemed to bind to my Radio, so I went through setting up modes and switches. But when I tried to arm it... Nothing. Connected my goggles and got video feed, only my OSD was flashing between "NoGyro" and "BadRx". And seeing that the sensors aren't picking up those components, I can't get it to arm or anything. I really need some help with this. If there is anything I can do other than buy a whole new AIO and install it. And BTW, I was just out flying it not 30min before this and it was flying fine. Or seemed to be, because I didn't notice anything out of the norm. But I'm sending out an S.O.S. Any advice is tremendously appreciated!

And P. s... Any of y'all old heads see what I did up there?? ☝️ 🎶Sending out an SOS🎶... Sorry.. had to break my aggravation just a little before I really broke something.