Good morning, so today we ran into an issue where the HMI showed an estop being pushed in. We went to every estop and manually reset it, afterwards we went to the safety relay and gave it some taps since the coil tends to not go in sometimes. Nothing was working and we decided to redo these steps to be sure. After doing it again we decided to look into the program and as we’re looking for the input for the estops it suddenly cleared. To which my question is, is there a signal issue where the estop is not making proper contact? Or could it be slow signal? Which doesn’t make sense, but I’m just annoyed at how it worked suddenly. Thanks in advance