So, I'm kinda new to FPV. After watching Josh Bardwell's videos on Betaflight, I decided to flash firmware on F411RX to 4.4.3... When I did it was successful and I went to configure my 'hawk and noticed the Accelerometer and gyro calibration buttons greyed out. So I went ahead and flashed back to factory firmware and restored my backup CLi dump. Still same problem. Went through binding process and it seemed to bind to my Radio, so I went through setting up modes and switches. But when I tried to arm it... Nothing. Connected my goggles and got video feed, only my OSD was flashing between "NoGyro" and "BadRx". I really need some help with this. If there is anything I can do other than buy a whole new AIO and install it. And BTW, I was just out flying it not 30min before this and it was flying fine. Or seemed to be, because I didn't notice anything out of the norm. But I'm sending out an S.O.S. Any advice is tremendously appreciated! I do have pics of my errors I got on BetaFlight if those will help. There is just a lot of them. I just don't want my first experience with FPV to be the one that changes my mind about the fun I could have in it.

And P. s... Any of y'all old heads see what I did up there?? ☝️ 🎶Sending out an SOS🎶... Sorry.. had to break my aggravation just a little before I really broke something.