SOLVED Compatibility issue with WT G1000 NXI

I just purchased the MilViz PC-6 and am having nothing but problems setting up my HC Bravo to work with it.

I have noticed the throttle axis on my HC Bravo does not properly reflect to what is being translated to the aircraft. With the throttle level on the Bravo in the fully retarded position (idle throttle in every other plane in the game), the throttle in the aircraft goes into full reverse. With the throttle lever on the Bravo in the full forward position, the throttle in the aircraft goes to idle. No matter which configuration i put in the controls menu, no setting will allow me to actual give it forward throttle. I can drag the throttle just fine in game, but that defeats the purpose of having the Bravo.

The only reverse thrust binding set in the controls menu is the the axis 1 “button. (Lever past the full aft detent)

It should be of note that both the condition lever and fuel lever are both working properly.

What ive tried so far: - Check for conflicting throttle axis binds (Checked, corrected, reset, and tested. Problem still persisting) - Set and reset the throttle axis on my Bravo - Attempted to reverse the axis, however, i get the same problem, but in reverse - Checked the manual to see if specific bindings were required for the aircraft

Anyone have any ideas? Anyone own the PC-6 and a HC Bravo that arent having this issue and mind sharing their bindings? I am at a total loss here. I have never had an issue like this before so this issue is rather foreign to me.