This post has been de-listed
It is no longer included in search results and normal feeds (front page, hot posts, subreddit posts, etc). It remains visible only via the author's post history.
72
Part I made today.
Post Body
Managed to program, setup, and run this today in 1 op! Pretty fun part all around. Has a couple of h tolerances on the OD. material is 316.
Comments
[not loaded or deleted]
Author
Account Strength
100%
Account Age
6 years
Verified Email
Yes
Verified Flair
No
Total Karma
13,754
Link Karma
4,033
Comment Karma
8,951
Profile updated: 5 days ago
Subreddit
Post Details
We try to extract some basic information from the post title. This is not
always successful or accurate, please use your best judgement and compare
these values to the post title and body for confirmation.
- Posted
- 9 months ago
- Reddit URL
- View post on reddit.com
- External URL
- reddit.com/gallery/18ht9...
could you shave a minute on that keyed slot by piloting both ends and then dropping the end mill centred on the two pilot holes and then the clear out to final sizing? also are just slot milling or doing some hsm on the keyway?