This post has been de-listed
It is no longer included in search results and normal feeds (front page, hot posts, subreddit posts, etc). It remains visible only via the author's post history.
No matter what I'm printing, it takes forever! I take a decent STL, slice it in Cura (or occasionally in Slic3r), load it up into OctoPrint (not Pi), and the time estimate is way off. Here's a few examples:
hand_part_0.gcode Estimated: 2.5 hours Actual: 4:23:22
head_5.gcode Estimated: 1.5 hours Actual: 4:01:54
Wrist_Linkage.gcode Estimated: 17 minutes Actual: 0:30:35
All these are printed at 0.175 layer height, 10% infill. Speed is set to 60mm/s in the slicer, but it certainly doesn't act like it's moving that fast.
Subreddit
Post Details
- Posted
- 7 years ago
- Reddit URL
- View post on reddit.com
- External URL
- reddit.com/r/MPSelectMin...