This post has been de-listed
It is no longer included in search results and normal feeds (front page, hot posts, subreddit posts, etc). It remains visible only via the author's post history.
2 part question: Pulled the circuit board from a foot pedal and installing it inside the guitar body. I'm very new to this. I have 2 Seymour Duncan Humbuckers connected to 1 500k Volume Potentiometer and no tone pots. I think I have the signal flow right...How do I solder a wire from the volume pot output (middle lug) and ground to the foot pedal input jack (6 pin)? then solder wires from the foot pedal output jack (4 pin) to the TRS of the guitar stereo output jack? It's my understanding once I unplug the guitar the 9V battery is no longer on. I'm not concerned about the foot pedal control knobs and fitting them through the pickguard. However, it's the on/off black circle button on the circuit board in the pictures that I need to reconfigure. I have this SPDT button that I want to use to turn the effect off and on. Of course when the button is all the way up it's off and down is on. I actually use a button like this to switch my pickups in one of my guitars. I took out the toggle switch and when the buttons up it's bridge humbucker. button down is neck humbucker. I don't care for coil splitting. I just like either neck or bridge. Anyways .... how can I wire this button onto the circuit board
Image seen in 1 other post by this user.
Image seen in 1 other post by this user.
Image seen in 1 other post by this user.
Image seen in 1 other post by this user.
Image seen in 1 other post by this user.
Image seen in 1 other post by this user.
Image seen in 1 other post by this user.
Image seen in 1 other post by this user.
Reposted Media Detected
One or more of the images in this post exist in 1 other post
Post Details
- Posted
- 10 months ago
- Reddit URL
- View post on reddit.com
- External URL
- reddit.com/gallery/1c0rk...