So, I have reloaded firmware, re-leveled, reloaded cura.. everything will move normally during the leveling process. When printing, it will move to the outside rim, then just raise up and start a line in mid air only to crash right back down into the glass bed.. then when moving to start the print it starts in mid air and scribbles. It seems like one of the stepper motors is slower than the others

Im wondering if it is the slicer / gcode.. but im using the same cura as I have other successful prints. Could it be something in the .stl’s? Or something in the gcode? Ive tried multiple prints with different stl’s but no luck

Im so frustrated with 3d printing right now. Everything seems to just break randomly with no cause.