Im using an rx 6600 xt hellhound. when I run it on pheonix miner without using afterburner it runs at 30mhs, but pulls 105w. if I apply my afterburner settings to the card before opening the miner, the miner will not load DAG and AMD gives me a driver timeout. if I apply while the miners running it drops to 0 mhs and blue screens. Am I making too big of a jump down in the core clock and up in the memory clock? I tried putting the parameters in my bat file and still no luck. I've had luck opening the miner and then slowly decreasing core and increasing memory and it works(I do not want to have to do this lol), but if I make too big of a jump up or down, the miner crashes as if I were to apply the afterburner with the miner running.

Edit: stock it starts at core- 2,615 & mem- 1990

I want it to be around core- 1335 & mem- 2350