So, as of my last post I had just finished turboing my sol. That didn’t end up going so well as I spun a rod bearing. After it spun I pulled the engine and front suspension and powder coated all of it the purple in the 4th pic. Except the subframe which I did black. I also have gotten my head fully rebuild with new guides, valve seals, valve job, etc. along with this I got my block decked and my cylinders bored over 1mm to fit forged 82mm low compression pistons. I also powder coated my turbo compressor housing. I’m about half way done at the moment with still needing to order my rods and a new crank along with all the gaskets and seals to start putting the engine back together. I’ll make another post when the engine is together on the stand/ back in the car. Hoping that doesn’t take too much longer but shit is expensive as I’m sure you have all figured out working on cars lol. Hope y’all’s builds are going well and enjoyed the little update on my car! Happy Sols!😁