Hey Dawn,

We've recently had a bit of a problem with our master population sheet, which everybody else's population sheet references to find their base population before any other modifier is applied to it.

Not to worry, for the fix is simple: all you need to do is put the following text into cell B2 of the "Other Modifiers" section of your population sheet. It should REPLACE the old text in the cell, rather than going in after it.

= IMPORTRANGE("1WOTLJl44mZN96U1dnHNEv6NGR7sQrS20jaVNW-uyEL4", "Stats!B2")

Just copy pasting it should be fine: if it works correctly, your sheet will load for a few seconds before arriving at the number 14354.

If anybody tracks their population carefully, they will then notice a population that is a bit bigger than it was shortly before the problem, which is because the numbers were previously for a 3.5x3.5km scale (since that looked to be winning at the time the population was accounted for) but are now adjusted for a 4kmx4km scale.

If anybody has any questions or problems implementing this, please let me know in the comments. Cheers.