So I will start this off with I am a QSC guy never have seen the BiAmp software till today. I was asked to help one of our technicians get it setup and no clue where to start i have the discovery tool downloaded and the Tesira software but do I just set up the amp in the software and push it that way? if so what is the default IP for the amp I do not see it listed in there documentation. I should also mention we are using the physical inputs on this amp not the networked. In the next 2 days we are installing these in in 2 locations 1 with a Tesiraforte AI and the other location with a third party amplifier. We ended up with these due to availability and timeline but again I am at a total loss on how to set the config to the amp. TIA