I recently bought a cb360 from a buddy of mine. It ran fine but i noticed when it was warmed up, it wanted to stall at idle. I took the carbs apart, gave them a good clean, adjusted the float, and threw them back on..... Then it ran like shit. I took them off and put them back on a bunch of times, because I had a sync issue, but I've since solved that. Now it runs fine at idle, until it gets warm, then it still wants to die slightly, but if i give it throttle it just kills the engine. The jets are all clean, so i'm wondering if the float level is set too low, or would it have something to do with the air/fuel mixture screw? Any insight would be appreciated .