This post has been de-listed
It is no longer included in search results and normal feeds (front page, hot posts, subreddit posts, etc). It remains visible only via the author's post history.
2
Glow in the dark filament will not stop stringing on cr10 v3
Post Body
Made a post about this a couple days ago and had a few responses. I tried everything I could think of to mitigate the stringing but it is consistent. I am using a hardened steel nozzle and I've done a temp test from 220 degrees to 180 degrees and every layer comes out the same. Dried the filament for 10 hours incase it held moisture. Ran retraction distance from .5 mm to 6mm. Increased retraction speed, travel speed. Enabled coasting and wiping. Running out of ideas on what to try next
Author
Account Strength
70%
Account Age
3 years
Verified Email
Yes
Verified Flair
No
Total Karma
59
Link Karma
2
Comment Karma
57
Profile updated: 59 minutes ago
Posts updated: 4 months ago
Subreddit
Post Details
We try to extract some basic information from the post title. This is not
always successful or accurate, please use your best judgement and compare
these values to the post title and body for confirmation.
- Posted
- 2 years ago
- Reddit URL
- View post on reddit.com
- External URL
- reddit.com/r/CR10/commen...