This post has been de-listed
It is no longer included in search results and normal feeds (front page, hot posts, subreddit posts, etc). It remains visible only via the author's post history.
I need some advice... I have an A1 mini that I have had to replace the toolhead board in. After the replacement was completed and everything was hooked back up my hot end temperature will not go below 150° but will heat up to the max of 300°. After researching it I found out that it has something to do with the usb-c cable that plugs into the board. Has anyone else ever ran into this problem and if so did you replace the usb-c cable or was it the connector on the toolhead board. I am not sure which it is. Since I bought the board from BBL should I just replace the cable or the board or both. ( FYI...I tried the other toolhead board that I replaced and it seemed to work right, could not be for certain because one of the screws ins for the Eddy sensor was broke of the board and was getting that error message.)
Subreddit
Post Details
- Posted
- 1 month ago
- Reddit URL
- View post on reddit.com
- External URL
- reddit.com/r/BambuLab/co...