So I've upgraded my P1P's extruder, and shortly after, ran into a couple clogs. It continued and has even been back-to-back.

It's more common after cancelling a print that is failing, though I don't know if the clog was what was causing the print to go bad, or if it was cancelling the print that caused the clog.

I have an Arc enclosure and part fan, but I've both tried the fan off, which doesn't help, and at the default 70% warps prints.
I'm about to try to print with the door open, but I'd love if there was a better solution.

I plan to also add a chamber fan to the back eventually; curious if that may help.

​

Thanks for any info regarding this! It has been driving me crazy and has been nearly my only grief with the printer.