Sorry, ARUBA noob here since my ARUBA guy has left.

​

One of my old controller has been down, so got RMA it.

(GuestWifi2) #show ver

Aruba Operating System Software.

ArubaOS (MODEL: Aruba7210-US), Version 6.5.4.12

Website: http://www.arubanetworks.com

(c) Copyright 2019 Hewlett Packard Enterprise Development LP.

Compiled on 2019-01-29 at 20:36:43 UTC (build 68901) by p4build

​

ROM: System Bootstrap, Version CPBoot 1.2.9.0 (build 78188)

Built: 2020-12-09 23:04:53

Built by: p4build@re_client_78188

​

​

Switch uptime is 2 hours 19 minutes 41 seconds

Reboot Cause: User reboot (Intent:cause:register 78:86:50:2)

Supervisor Card

Processor (XLP416 Rev B2 (Secure Boot) , 800 MHz) with 7370M bytes of memory.

32K bytes of non-volatile configuration memory.

7928M bytes of Supervisor Card system flash.

​

As you can see, both WiFi1 and WiFi2(RMA) are same hardware, same OS code.

Due to we have AP105s (ancient) we cannot really risk to upgrade OS code.

​

My strategy is get sh run configs from WiFi1, modify some mgmt IPs then copy paste into WiFi2, just like Cisco stuff.

​

And new box (WiFi2) just doesn't take it.

For an example, in config from WiFi1, there is something like "(GuestWifi1) (config) #user-role ureadyintranet"

But same command won't work in WiFi2. There isn't such user-role.

​

How can I configure this WiFi2????