Not asking for troubleshooting here so I’m not going thru all of the requests for info. But here goes on the relevant stuff.

M5C, got the Anker factory two sided plate for the bed as I wanted my original to have a G10 side. So I elected for the new plate to be the combo PEI on one face and the grey epoxy on the other. I think k they even referred to it as soft epoxy on the website.

Now here is my question-what would you use the smooth epoxy side for? Is it good for PETG that’s super sticky? Or TPU that can rip off pieces of the PEI sheet?

I got the G10 for Nylons and maybe PETG, I have had great luck with ASA on the PEI with a glue stick, TPU sticks too well to PEI, and PLA of course prints easy on most surfaces…

What say you on Anker experts, what should I try printing with on the Anker epoxy bed?