Hey All, i've been printing with ABS for a while bit i've always struggled with the extruder starting to get closer to the print as it progresses. This is only a real issue with larger prints but i'm sure its affecting my smaller prints too. I've been baby-stepping up during larger prints but i end up with prints taller than they should be. I've calibrated my Z steps/mm with a 1x2x3 block, all is well there. And my E-Steps are calibrated perfectly as well. The only solution i can think of is dialing back my flow significantly so that i'm printing less material. I'm on an Artillery X2, Sunlu ABS filament. 240/100C. Thanks in advance for any advice!