Hello!

So I got my Makergear M2 dual upgrade installed, both extruders working well, starting height set, etc.

I imported all some dual extruder profiles from a makergear forum member and they're great! Only issue I'm having is that, on ANY dual color print besides the dual color calibration cube, my first few layers and the entire ooze shield are printing at 2.2mm/s. which is CRAWLING, to the point where the ooze shield is worthless since all of the oozing is being done before the shield is in place.

I'm not sure if there is a setting for this, or if S3D is just being dumb on me?

edit - ok so i found out that when supports are generated, it runs normal speed, but when I remove supports it slices and prints at 2mm/s...