I'm not sure if this is whats happening, but I woke up to what I think is a clogged nozzle this morning. The print I had started under extruding about half way though and failed miserably as a result. I tried starting a new one this morning after I woke up and instead of feeding into the nozzle the feeder starts clicking like its skipping. I've tried doing 2 cold pulls but nothing happened. I'm unable to force it through the nozzle either. When I heat up the nozzle for a cold pull nothing comes out when I push on it. I've been using PLA at default cura settings. I've only had this thing since friday. I've had far more troubles that I had anticipated.