I recently got my Ford Pro and so far it's been working great. Last night I set up a print and used a spool that I thought had enough filament on it, but I was mistaken. Woke up and saw that it stopped at 98% due to the school about to run out. I swapped in another spool (that I had printed from before earlier that day) and hit continue. Unfortunately my printer went through the motions, but was not actually extruding anything and just making a clicking noise.

I took the filament out and put the needle through and got a little bit of black residue, but not enough that I I think that the cause was a clog. I put the filament in and try to start a new print, but the same issue persisted. I cut the tip of the filament off, about an inch, and try it again but no luck.

Any other suggestions on what it could be? My temps and settings haven't changed.