https://imgur.com/a/nMpUWV5

The imagur vid explains it all more or less, I am trying to level all 4 of my corners, I am tightening every corner as much as would go and then unTightening every corner buy 2 spins, then I go to my printer level corners and I go from there, each corner I have to tie in a little bit and it's fine, but the top right corner, for whatever reason is too close to the nozzle, I can't tighten it anymore, and I'm not really, sure, what's going on? It's just the one corner before hand. I've had issues where I've had to loosen a corner, so much to the point that the wheel was pretty much falling off, but now I'm having the opposite issue