Does anyone else have this problem. I'm an I.V. user and live in the North East(U.S.). No matter which connect I see (all Dominicans in Lawrence, MA) and no matter how much I load into the rig (0.25g - 0.8g, depending on source), it ultimately turns into a coagulated mess almost instantly.

I typically use around 70-80 units of water and I heat it just enough so I can draw it up (without heat there is no chance of drawing it up if its over say 0.4g). And within seconds of entering the rig, it is no longer a liquid. So I'm forced to cut the needle and a bit of plastic off, squirt back into spoon, and this usually solves the problem. About 50 units of liquid squirt out and around 10-15 units of solid matter stay in the cut open rig. So I then add about 10 units of water to the spoon with the 50 units of liquid I got out of the rig, and I can then draw up this fresh 60 units into a fresh rig. It's a real pain in the ass. Idk what kind of cut they are using out here, but it's not meant to be used by IV users.

Anyone have similar issues? Any work arounds? Solutions?